|
| 1-Hassanzadeh, R., Khalili, M.,, Replacing the wet cooling tower with a ground source heat exchanger as a clean technology,Journal of Building Engineering, 2018. | |
| 2-Hassanzadeh, R., Darvishyadegari, M.,, Influence of rotation on the heat and fluid flow around a circular cylinder,International Journal of Modern Studies in Mechanical Engineering (IJMSME), 2018. | |
| 3-Arman, S., Hassanzadeh, R., , Effects of the geometric parameters on the thermal-hydraulic performance of the wavy tubes,International Communications in Heat and Mass Transfer, 2018. | |
| 4-Darvishyadegari, M., Hassanzadeh, R.,, Analysis of the convective heat transfer and flow behavior around two counter-rotating side-by-side cylinders,Heat transfer- Asian Research, 2018. | |
| 5-Hassanzadeh, R., Arman, S., , Improvement of thermal performance of the floor heating system using the metallic bridges,Energy Engineering & Management, 2018. | |
| 6-Darvishyadegari, M., Hassanzadeh, R., , Heat and fluid flow around two co-rotating cylinders in tandem arrangement,International Journal of Thermal Sciences, 2019. | |
| 7-Hassanzadeh, R., Marami Mashoof, F, Darvishyadegari, M., , Three-Dimensional Study on the Heat Transfer Process in Cast-Iron Sectional Boilers,Arabian Journal for Science and Engineering, 2018. | |
| 8-Hassanzadeh, R., Darvishyadegari, M., , Analysis of heat and fluid flow around two co-rotating side-by-side cylinders,Sadhana, 2019. | |
| 9-Hassanzadeh, R., Marami Mashoof, F, Darvishyadegari, M.,, A Comparative Three-Dimensional Study about the Effects of the Hot Gas Passages on a Sectional Cast-Iron Boiler Performance,International Journal of Modern Studies in Mechanical Engineering (IJMSME), 2018. | |
| 10-Hassanzadeh, R., Tokgoz, N., , Analysis of heat and fluid flow between parallel plates by inserting triangular cross-section rods in the cross-stream plane,Applied Thermal engineering, 2019. | |
| 11-Hassanzadeh, R., Shams, M., Darvishyadegari, M., , An environmentally friendly idea for cooling of water in water-cooled chillers in urban areas,International Journal of Advanced Research in Physical Science (IJARPS), 2019. | |
| 12-Hassanzadeh, R., Mohammadnejad, M., , Effects of inward and outward overlap ratios on the two-blade Savonius type of vertical axis wind turbine performance,International Journal of Green Energy, 2019. | |
| 13-Hassanzadeh, R., Mohammadnejad, M., , Effect of overlapping size on the performance of the Savonius wind turbine, in both conventional and the Bach-type models,Modares Mechanical Engineering, 2019. | |
| 14-Hassanzadeh, R., Abadtalab, M., Bayat, A., , Optimization of wave inclination angle in parallel wavy‑channel heat exchangers,Arabian Journal for Science and Engineering, 2020. | |
| 15-Hassanzadeh, R., Darvishyadegari, M., Arman, S., , A new idea for improving the horizontal straight ground source heat exchangers performance,Journal of Sustainable Energy Technologies and Assessments, 2018. | |
| 16-Hassanzadeh, R., Rahimi, R., Khosravipour, A., , Thermal behavior of a hot flat plate passing between two counter-rotating cylinders,International Communications in Heat and Mass Transfer, 2019. | |
| 17-Hassanzadeh, R., Pirdavari, P., Akbari Rendi, M., , Effects of hot gas passages on the performance of multi-pass cast iron sectional boilers,Applied Thermal Engineering, 2017. | |
| 18-Sepehrianazar, F., Hassanzadeh, R., Mirzaee, I., , Turbulence and energy assessment of a two bladed H-type vertical axis wind turbine between two high-rise buildings,International Journal of Heat and Technology, 2019. | |
| 19-Hassanzadeh, R., Khanjaripour, S., , An Innovative Method for Enhancing the Local Wind Potential around the Vertical Axis Wind Turbines at Low Potential Regions,International Journal of Advanced Research in Physical Science (IJARPS), 2018. | |
| 20-Hassanzadeh, R., Khosravipour, A., Rahimi, R., , Interaction between a hot flat plate and two counter-rotating side-by-side cylinders,International Journal of Thermal Sciences, 2020. | |
| 21-Hassanzadeh, R., Ozbek, A., Bilgili, M., , Analysis of Alumina/Water Nanofluid in Thermally Developing Region of a Circular Tube,Thermal Engineering, 2016. | |
| 22-Hassanzadeh, R., Rahimi, R., Khosravipour, A., Mostafavi, S., Pekel, H., , Analysis of natural convection in a square cavity in the presence of a rotating cylinder with a specific number of roughness components,International Communications in Heat and Mass Transfer, 2020. | |
| 23-Hassanzadeh, R., , Best location of the small wind turbine around a single high-rise building,International Journal of Green Energy, 2017. | |
| 24-Nasrollahzadeh, S., Hassanzadeh, R.,, Heat transfer enhancement in a spiral plate heat exchanger model using continuous rods,Journal of Heat and Mass Transfer Research, 2020. | |
| 25-Bilgili, M., Hassanzadeh, R., Sahin, B., Ozbek, A., Yasar, A., Simsek, A., , Investigation of wind power density at different heights in the Gelibolu Peninsula of Turkey,Energy Sources, Part A, 2016. | |
| 26-Sepehrianazar, F., Hassanzadeh, R., Mirzaee, I., , Investigation of effect of free-wind velocity on the performance of small-scale vertical axis wind turbine,Amirkabir Journal of Mechanical Engineering, 2021. | |
| 27-Hassanzadeh, R., Pekel, H., , Assessment of thermal performance of the functionally graded materials in annular fins,Journal of Engineering Thermophysics, 2016. | |
| 28-Hassanzadeh, R., Rahimi, R., Pekel, H., , Effects of Shell Aspect Ratio and Combustion Chamber Location on Thermal–Hydraulic Performance of Hot-Water Steel Boilers Under Steady-State Operation,Arabian Journal for Science and Engineering, 2021. | |
| 29-Hassanzadeh, R., Mohammadnejad, M., Mostafavi, S., , Comparison of Various Blade Profiles in a Two-Blade Conventional Savonius Wind Turbine,Journal of Energy Resources Technology, 2021. | |
| 30-Hassanzadeh, R., Bilgili, M.,, Assessment of thermal performance of functionally graded materials in longitudinal fins,Journal of Engineering Physics and Thermophysics, 91(1): 79-88. | |
| 31-Darvishyadegari, M., Hassanzadeh, R., , Convective heat transfer and fluid flow of two counter-rotating cylinders in tandem arrangement,Acta Mechanica, 2018. | |
| 32-Hassanzadeh, R., , Effects of unsteady flow generation over a hot plate on the cooling mechanism using a rotating cylinder,Arabian Journal for Science and Engineering, 2018. | |
| 33-Hassanzadeh, R., Tokgoz, N.,, Thermal-hydraulic characteristics of nanofluid flow in corrugated ducts,Journal of Engineering Thermophysics, 2017. | |
| 34-Hassanzadeh, R., Bilgili, M., , Improvement of thermal efficiency in computer heat sink using functionally graded materials,Communication on Advanced computational Sciences with Applications, 2014. | |
| 35-Hassanzadeh, R., Pekel, H., , Heat transfer enhancement in annular fins using functionally graded material,Heat Transfer-Asian Research, 2013. | |
| 36-Hassanzadeh, R., Sahin, B., Ozgoren, M.,, Large Eddy Simulation of flow around two side-by-side spheres,Journal of Mechanical Science and Technology, 2013. | |
| 37-Hassanzadeh. R, Sahin, B., Ozgoren, M., , Large eddy simulation of free surface effects on the wake structures downstream of a spherical body,Journal of Ocean Engineering, 2012. | |
| 38-Hassanzadeh. R, Sahin, B., Ozgoren, M., , Numerical investigation of flow structures around a sphere,International Journal of Computational Fluid Dynamics, 2011. | |
| 39-Hossainpour, s., Hassanzadeh, R., , Numerical investigation of tube side heat transfer and pressure drop in helically corrugated tubes
,International Journal of Energy an Environmental Engineering, 2011. |
|